Chosen Solution

My Oven Door - Jenn Air model# JMW9527BAB, does not have the standard removal method. No sliding bar or the ability to lift & remove. The dust inside the glass is terrible, so I want to remove & clean. Any ideas?

stuart, here is what the service manual suggest : Open the oven door as wide as possible. Place an 1/8" pin in the hole on the right and left door hinges, see Figure 2-1, Remove the screws from each side with a Phillips screwdriver. Remove the lock plate from each side, Figure 2-1 Raise the oven door up to a broil stop position. In this position, it will be against the 1/8" pin. Grasp the door toward the top on both sides. Lift the door up and out to remove.

“SERVICING OVEN DOOR

  1. Lay the oven door on a protected surface with the inner door panel facing down.
  2. Remove three screws from lower trim.Remove trim piece.
  3. Slide outer-door glass down to disengage from top trim. Remove.
  4. Remove three screws from top oven door trim. Remove the two 3/8” nuts from the door handle bracket.
  5. Lift up and off. This will disengage the side trim as well.
  6. Remove the oven window pack by removing the 3/8" nuts from the insulation retainer." Hope this helps, good luck.

How do i adjust the door to close fully/ completely. My jenn-air oven model is JMW9527CAB thanks James